admin-it
About
- Username
- admin-it
- Joined
- Visits
- 3,033
- Last Active
- Roles
- Administrator
Comments
-
Its just the way the icon units operate, just not a great system that they have, Hopefully you purchased a extended warranty on that unit.
-
Did you purchase belt from us? If so i would send pics of belt over to customer service with your order#. customer.service@treadmilldoctor.com
-
They are both made by the same company so both are about the same.
-
simple green
-
try using a dry rag and wipe it off or try simple green and a rag and clean off belt
-
replace lower board Error 300 Low Voltage An analog reading indicated that the dc voltage to the belt motor dropped while the belt was running. 1. check that they are using a dedicated line 2. check they are not using an extension cord that is too s…
-
Sounds like a short in the controller
-
https://www.treadmilldoctor.com/landice-l7-pro-sports-trainer-treadmill-review
-
Nordictrack sells a CONSOLE REPROG MICRO SD CARD that may solve your issue and the cost of that is $116.89 plus shipping.
-
Sounds like your motor controller has gone bad, they are $279.99 plus Shipping.To order please call me 888-362-1105 then enter Ext 331 and ask for Jim
-
Its a motor controller issue.
-
Sorry, The only console you can put on that is the one that came with the unit and at this time they are out of stock.
-
Err Code 22 - (Bad Scr) Indicates malfunction of the circuitry that controls motor speed. 1. Bypass the wire harness between the control panel circuit board and the power supply circuit board with a spare wire harness. If the error is corrected, ins…
-
Could be that the treadmill does not have enough cushion to the deck, Try stretching before using the treadmill.
-
Yes the 2 flanges get mounted to the arm that comes out from hood cover area.
-
https://www.treadmilldoctor.com/icon-pb-12i-troubleshooting
-
Most 375e don't have incline displayed on consoles.
-
Sounds like you have a console issue going on.
-
https://support.johnsonfit.com/resource.php?url=http://productload.johnsonfit.com/inc/uploaded_media/4f7300de6c8933e47075cfeb1ab3998f/calibration_guide/c52edb5e3bfdd97876963bbc492ca602.pdf
-
Could be a weak motor
-
I would contact spirit
-
No way yo adjust , its in your body motion.
-
Yes we have seen this before.
-
Could be caused buy a worn walking belt
-
Try to calibrate system, https://www.treadmilldoctor.com/icon-calibration-mc2100
-
When you press the start button, does the time start to count up on screen? If it does then you have a motor controller that has gone bad, if the time does not start then you have a console issue.
-
Sound like the walking belt is worn out.
-
Just use manual mode. file:///C:/Users/jimvo/Downloads/PFTL89515.0-381847%20(1).pdf
-
Try Running unit without anyone on and see if unit will show a LS1, if it does not then you know you have a issue with friction which is caused by a worn out walking belt.
-
LS1 is a issue cause by a worn walking belt and overtime it will cause damage to the Motor controller.