admin-it
About
- Username
- admin-it
- Joined
- Visits
- 3,032
- Last Active
- Roles
- Administrator
Comments
-
What seems to be the issue?
-
Sorry we do not.
-
Sounds like you have a motor controller failure. Do you have the complete model number its located on a sticker down on the frame close to the floor ,
-
Do you have the complete model number its located on a sticker down on the frame close to the floor when you fold unit up. Also you can look under the hood cover and there is a piece of paper inside a envelope that has the model number on the paper.
-
I would test the motor, if motor test good then the motor controller has gone bad and would need to be replaced. https://www.treadmilldoctor.com/motor-testing
-
Could be a motor controller, I would test drive motor to see if its good, if motor test good the you have a bad controller. https://www.treadmilldoctor.com/motor-testing
-
The E-2 error code is displayed in the speed window if no speed signal is received five seconds after either the speed up or program start button is pressed. Possible causes include a faulty speed sensor, the speed encoder disk not being positione…
-
Normal amp draw with load is 6 to 8 amps, sounds like a worn walking belt. If you need to purchase parts below is a discount code. Discount Code - COPY AND PASTE this code, 1982 in the discount code box for a 5% discount off your order,
-
-
https://www.treadmilldoctor.com/pacemaster-proplus-hr-treadmill-safety-key Discount Code - COPY AND PASTE this code, 1982 in the discount code box for a 5% discount off your order,
-
Contact proform if its still under warranty
-
Glad to hear they are sending someone out!
-
A lot of machines keep the resistance point of the last workout when next starting up without power... do you end your workouts at high resistance levels?
-
yes please let us know as we find this pretty much unacceptable considering the price range also
-
Our techs are saying this is normal in some of the models
-
GM! please check to make sure all wires are securely plugged in inside make sure there is no crimping in the wires It could be that the lower board is not sending voltage to the console and the only way to know this is if you have a voltmeter and …
-
GM! It is either friction in the belt or a bad wiring connection - change out the drive belt and check for scorching in any of the wiring... there is also a test for the motor to make sure it has not been cooked... https://www.treadmilldoctor.com/m…
-
Try gluing the collar with super glue.
-
no only fedex & UPS
-
Calibration for the & DMTX2i Resistance Motor This should solve the 30 second pause issue in unit 1. Please remove the right side pedal arm, the teardrop cover, and the white disc. 2. Then, loosen the set screw on the limit…
-
We have sold out of all those old smooth parts. Sorry
-
We don't have any info on the incline motor itself, besides it no being available any longer.
-
good luck
-
https://www.treadmilldoctor.com/nordic-track-c2400-model-ntl098061-motor-control-board Discount Code - COPY AND PASTE this code, 1982 in the discount code box for a 5% discount off your order
-
The motor controller has failed. Do you have the complete model number its located on a sticker down on the frame close to the floor when you fold unit up. Also you can look under the hood cover and there is a piece of paper inside a envelope that h…
-
We can't do anything about the shipping.
-
Sounds like you have a motor controller that has gone bad.
-
good luck
-
Sounds like a control board failure