admin-it
About
- Username
- admin-it
- Joined
- Visits
- 3,420
- Last Active
- Roles
- Administrator
Comments
-
Sounds like the motor controller is Bad.
-
Its in the console, you can try to unplug the ribbon cable clean the end with contact cleaner and then try it again.
-
Yes they are $199.99 plus $6.99 shipping. All I need are the measurement of the deck- length x width x thickness and if you have any cut outs at the front of the deck. (Example 5 1/2" in from each side and 2 3/4" down from the front edge. call me at…
-
Really sound like the belt & deck are worn out. when your ready to order please call me at 888-800-1167 then enter ext 331 and ask for Jim.
-
Sounds like your belt & deck may be worn out, when was the last time you lube the belt & deck?
-
When you press the start button the the time on console start to count up? If not then its a problem with console.
-
That roller sleeve is is $29.99 and you can order that by calling me at 888 800 1167 and then dial my ext 331. www.treadmilldoctor.com/installation-roller-traction-sleeve
-
What is the model number of your treadmill?
-
Reinstall it the same way you took it out of your treadmill.
-
Have you taken a amp draw test on the unit. www.treadmilldoctor.com/dc-amp-draw
-
When you took the motor apart, did it seem like there was a lot of resistance when pulling the commutator out if not sounds like the magnets may be shoot.
-
Sounds like you need a new drive motor.
-
You can purchase a aftermarket running belt.
-
Should be able to twist drive belt back and fourth at about a 45 degrees know more or less
-
That tells me that your drive belt (D) needs to be tighten down more.
-
When the running belt stops, does the front roller stop and does the pulley on front roller continue to spin or does that stop spinning also.The reason I ask is that the front roller pulley should spin when roller does and not spin when roller is st…
-
When stepping on the belt and the front roller stops and so doe the drive belt , does drive motor also stop or does it continue to spin?
-
I would contact true, but it sounds like a stuck key on the membrane.
-
Good solid unit, not sure when it was last made.
-
No you would have to replace the entire rear roller itself.
-
The motor controller is down by your feet under the hood cover with the motor,what model treadmill do you have.
-
Alright, when you press the start button on console does your time start to count up, if it does then you are looking at a motor controller that needs to be replace. But if the time does not start to count up then its a console issue.
-
The unit has sealed bearing in the rollers , so they cannot be lube.
-
I don't think its a fuse, make sure you have the safety key install on console.
-
Display did not switch over into metric mode did it?
-
Never heard of that brand Treadmill.
-
Replace front roller
-
I would replace the front bearings or entire front roller and see if that helps.
-
May need to adjust walking belt at the rear, or may need to lube the belt.
-
Its a average price for that unit , I would try for $200 even