admin-it
About
- Username
- admin-it
- Joined
- Visits
- 3,681
- Last Active
- Roles
- Administrator
Comments
-
Couldn't really tell , because unit is running alright now.
-
call spirit and see if they have one.
-
Could be a error 1 or error 2
-
Sounds like it may be a motor controller down below that has gone bad.
-
Good luck
-
We may I just need the complete model number of the treadmill, its on a sticker located on the frame.
-
The MC-2100 has a single test light. The meaning of the operation of the test light is: If light it off - the board has no detectable input AC power. If light is on and glowing solid - It is receiving AC power but no speed signal from the console. …
-
The MC-2100 has a single test light. The meaning of the operation of the test light is: If light it off - the board has no detectable input AC power. If light is on and glowing solid - It is receiving AC power but no speed signal from the console. …
-
Good luck with your new treadmill.
-
Error 133 Command Timeout The controller did not receive a response to a command within 0.5 seconds. 1. replace harness 2. replace lower board.
-
Sounds like its a motor controller that may be bad.
-
Your breaker is broken and would need to be replaced.
-
Your deck & belt look a little worn, so maybe the belt is sticking/slipping which would cause the problems with your knees.
-
Sounds like the belt & deck need to be lube.
-
Error 307 Belt Stalled The belt stopped for 1 second while belt speed control was active or failed to start moving within 3 seconds at startup. 1. check that belt was not being “held” during startup 2. replace lower board (NO LONG AVAILABLE 3. c…
-
Make sure you buy a extended warranty its worth it.
-
Good luck.
-
Troubleshooting Lights- What They Mean D11- Labeled +12v - This light means that the MC-60 is receiving AC power from either the power supply or the wall outlet (if direct wired to AC) and it outputting a small voltage on the speed circuit. If you c…
-
Error 306 Soft Start Soft start circuit failed to charge the capacitor at start-up. 1. replace lower board ( they are no longer available. 2. You can call Jason from Arkansas fitness 501-450-6283 and he will repair it if you send board into him.
-
I would go with the sole and buy a extended warranty with either one its worth it.
-
No, sole is one of the lowest sitting treadmill out there.
-
Have you tried to calibrate incline motor? ICON CALIBRATION INSTRUCTIONS- INCLINE The standard calibration procedure to calibrate an Icon treadmill is done by holding down the speed up and stop keys while inserting the safety key or putting the key …
-
I would go with the Nodrictrack, they both come out of the same factory, but the Nordictrac is a little nicer.
-
I would just replace drive belt.
-
Sounds like a drive belt is just dried out.
-
Sounds like the drive belt.
-
Try looking at the steps below to see what be wrong with your unit.
-
Contact customer service with your order number.
-
You can't really repair the deck, its a phenolic deck. its a very thin layer of material on the deck.
-
Yes, The f80 is a very nice unit, worth the extra.