admin-it
About
- Username
- admin-it
- Joined
- Visits
- 3,293
- Last Active
- Roles
- Administrator
Comments
-
I would just replace drive belt.
-
Sounds like a drive belt is just dried out.
-
Sounds like the drive belt.
-
Try looking at the steps below to see what be wrong with your unit.
-
Contact customer service with your order number.
-
You can't really repair the deck, its a phenolic deck. its a very thin layer of material on the deck.
-
Yes, The f80 is a very nice unit, worth the extra.
-
Could be possible.
-
Try this: ICON CALIBRATION INSTRUCTIONS- INCLINE The standard calibration procedure to calibrate an Icon treadmill is done by holding down the speed up and stop keys while inserting the safety key or putting the key in place (if magnetic). If your k…
-
Just sounds like the front roller bearing are bad, you can try to spray some wd-40 into the shaft goes threw the bearings, sometimes this will clear any debris in and around bearing.
-
If you can't dig your nails in on the underside of belt that tells you it needs to be replaced.
-
Now when you hit start button on console does the time start to count up?
-
Does the console turn on?
-
Quinton- Most parts on that unit are no NLA. Nordic track- most parts you can still buy , except the console. I would still go with a landice great unit have been working on those since 1991
-
When the any electric motor starts it sometimes will arch and that why it will trip a gfci or a afci breaker/outlet. That's the function of a GFCI or AFCI breaker to trip if it senses any type of arch/spark etc.
-
I would suggest lubricating the belt every 6 months with treadmill world famous lube.You could take a amp draw reading to see what the amps are with load and without load. Also you should be able to dig your finger nails into the underside of belt, …
-
I would go with the sole and purchase a extended warranty, sole has a much better customer service department and unit are built very well.
-
Good luck
-
Hold down the Stop button and the Speed increase button, insert the key into the console, and then release the Stop button and the Speed increase button. Press the Stop button and then press the Incline increase or decrease button. The treadmill wil…
-
You should check the tension of drive belt, grab the edges of the drive belt with your thumb and forefinger and should not be able to twist it more then a 45 degree angle. If you can then belt needs to be adjusted or replaced.
-
If you can get it for that price that's a great deal, the unit is almost 3 year old model so it may be a left over
-
Sounds more like the console assembly and they are $379.65 but are out of stock at this time.
-
we have them , they are $5.99 plus $6.99 shipping.
-
I would go with the landice treadmill.
-
I would check down below inside bike and make sure your speed sensor is inline with the magnet when flywheel spins.
-
So if you install safety key and hit the Go Button will the time start to count up?
-
No, I would not buy a used motor controller, would only purchase a brand new one with warranty.
-
Yes, they are in stock and the part # is 252234 and they are $149.99 plus shipping.
-
Yes, the motor controller is bad.
-
You would have to contact icon for that information.