admin-it
About
- Username
- admin-it
- Joined
- Visits
- 2,453
- Last Active
- Roles
- Administrator
Comments
-
GM! It is either friction in the belt or a bad wiring connection - change out the drive belt and check for scorching in any of the wiring... there is also a test for the motor to make sure it has not been cooked... https://www.treadmilldoctor.com/m…
-
Try gluing the collar with super glue.
-
no only fedex & UPS
-
Calibration for the & DMTX2i Resistance Motor This should solve the 30 second pause issue in unit 1. Please remove the right side pedal arm, the teardrop cover, and the white disc. 2. Then, loosen the set screw on the limit…
-
We have sold out of all those old smooth parts. Sorry
-
We don't have any info on the incline motor itself, besides it no being available any longer.
-
good luck
-
https://www.treadmilldoctor.com/nordic-track-c2400-model-ntl098061-motor-control-board Discount Code - COPY AND PASTE this code, 1982 in the discount code box for a 5% discount off your order
-
The motor controller has failed. Do you have the complete model number its located on a sticker down on the frame close to the floor when you fold unit up. Also you can look under the hood cover and there is a piece of paper inside a envelope that h…
-
We can't do anything about the shipping.
-
Sounds like you have a motor controller that has gone bad.
-
good luck
-
Sounds like a control board failure
-
Its just the way the icon units operate, just not a great system that they have, Hopefully you purchased a extended warranty on that unit.
-
Did you purchase belt from us? If so i would send pics of belt over to customer service with your order#. customer.service@treadmilldoctor.com
-
They are both made by the same company so both are about the same.
-
simple green
-
try using a dry rag and wipe it off or try simple green and a rag and clean off belt
-
replace lower board Error 300 Low Voltage An analog reading indicated that the dc voltage to the belt motor dropped while the belt was running. 1. check that they are using a dedicated line 2. check they are not using an extension cord that is too s…
-
Sounds like a short in the controller
-
https://www.treadmilldoctor.com/landice-l7-pro-sports-trainer-treadmill-review
-
Nordictrack sells a CONSOLE REPROG MICRO SD CARD that may solve your issue and the cost of that is $116.89 plus shipping.
-
Sounds like your motor controller has gone bad, they are $279.99 plus Shipping.To order please call me 888-362-1105 then enter Ext 331 and ask for Jim
-
Its a motor controller issue.
-
Sorry, The only console you can put on that is the one that came with the unit and at this time they are out of stock.
-
Err Code 22 - (Bad Scr) Indicates malfunction of the circuitry that controls motor speed. 1. Bypass the wire harness between the control panel circuit board and the power supply circuit board with a spare wire harness. If the error is corrected, ins…
-
Could be that the treadmill does not have enough cushion to the deck, Try stretching before using the treadmill.
-
Yes the 2 flanges get mounted to the arm that comes out from hood cover area.
-
https://www.treadmilldoctor.com/icon-pb-12i-troubleshooting
-
Most 375e don't have incline displayed on consoles.