admin-it
About
- Username
- admin-it
- Joined
- Visits
- 3,282
- Last Active
- Roles
- Administrator
Comments
-
we don't have those lower boards for those.
-
Its a motor controller, make sure you order by your complete model number which is located down on the frame once you fold it up, also found under the hood on the wiring diagram. you can use discount code below to save 10% on all parts at www.treadm…
-
Normally you will need a crank puller which in your case it would a 22mm
-
Yes you need a safety key for unit to operate.
-
Sounds like the lower motor controller has gone bad.
-
Good luck
-
Good luck
-
Good luck with your purchase
-
Sounds like the motor controller has shorted out, when was the last time you replace the walking belt or even lube the walking belt.
-
No fuse, if you have a light lite on the lower board that tells you that you have AC power coming into unit. If you have a voltmeter you can check to see if you have power going to console on the red wire & the black wire should be between 8 to …
-
Our belts come pre lube, but should be relube every 6 months.
-
https://www.treadmilldoctor.com/horizon-gs1050t-model-number-tm627-motor-controller-part-number-032669-if Once you've added items to your cart, and you are ready to check out you can put this Discount Code 10OFFJAMES in the Discount box on the che…
-
Once you've added items to your cart, and you are ready to check out you can put this Discount Code 10OFFJAMES in the Discount box on the check page where you put in your billing and shipping information at. You will see your discount amount applie…
-
could be in the overlay/ membrane itself or upper console.
-
No i can't think of one component
-
Enjoy the unit
-
Sounds like a rpm sensor is not picking up , may need to be adjusted or replaced.
-
Make sure you lube walking belt every 6 months.
-
Sounds like a console and they are no longer available, but you can try to unplug small thin ribbon cable that goes from keypad and plugs into the console printed circuit board. Just unplug it clean the ends off the plug back in.
-
Just unplug one wire at a time and then plug into the new board.
-
I would spary under the siderails with a wd40 because the side rails slide off and they may be stuck due to age and sweat.
-
I would check the speed sensor and make sure gap is good, also I would lube the belt.
-
-
-
Sounds like a bad controller.
-
The console will beep until you adjust the max speed pot on lower board
-
Did you try to adjust max speed pot on lower board?
-
It should work
-
DRIVE BELT REPLACEMENT