admin-it
About
- Username
- admin-it
- Joined
- Visits
- 3,283
- Last Active
- Roles
- Administrator
Comments
-
Where did you purchase motor controller from?
-
When you put in new motor controller did ou calibarte unit.
-
Its a problem within the motor controller. https://www.treadmilldoctor.com/horizon-cst-3-5-motor-control-board Once you've added items to your cart, and you are ready to check out you can put this Discount Code 10OFFJAMES in the Discount box on the…
-
Error 304 Remote Start Remote enable signal from the controller did not perform the correct start-up sequence. 1. re-seat harness on lower board 2. replace harness 3. replace lower board The lower board is no longer available to purchase.
-
On that model you actually need to take base frame off of the main upright frame and then you will have access to the front roller. Do not bang shaft out from roller.
-
Take your wheel out and measure the center hole dia and see if a roller blade wheel will work.
-
Yeah, that part they no longer make.
-
The motor controller went on you. https://www.treadmilldoctor.com/proform-crosswalk-405e-model-246330-motor-control-board Once you've added items to your cart, and you are ready to check out you can put this Discount Code 10OFFJAMES in the box Disc…
-
check all your connections from controller to console and make sure harness did not get pinched. F & S Series Engineering Mode Remove tether cord. Press and hold Start, Enter, and Stop. Replace tether cord Display should go Engineering M…
-
Sounds like incline motor issue.
-
Your unit uses part # 363002 and the others use part # 286547 and they are not the same in size and the inner hole diam is different.
-
You can't go wrong with either one, I would recommend buying a extended warranty if you are able to on either unit.
-
LUBE DECK ADJUST TENSION ON BELT ALIGNING BELT
-
what is your serial number?
-
https://www.treadmilldoctor.com/bestbuyawards-treadmill
-
Here is the part # 241949 you will need. We don't have your unit listed ,but any unit using that part number will work. You can put this discount code 2158222590 in the Discount box on the checkout page where you put in you billing and shipping info…
-
Resistance motor is bad.
-
Sounds like a resistance motor.
-
Sounds like maybe it could be in the metric mode.
-
If decide to purchase a new motor controller here is a code that will save you 10% on the part. You can put this discount code 2158222590 in the Discount box on the checkout page where you put in you billing and shipping information into and receive…
-
Sounds like a motor controller is bad.
-
Great Job.
-
Replacing drive belt on frame style A elliptical Replacing drive belt on frame style B elliptical Replacing drive belt on frame style C elliptical
-
Our belt is a little thinner then the oem, we can order you a OEM belt but it cost $103.89 plus $19.99 shipping. To order please call me 888-362-1105 then enter Ext 331 and ask for Jim.
-
Sometimes it held on with a clip also.
-
We have never experience any problems with our drive belts failing on units, since we have been selling them for the last 15 years.
-
The on/off switch is turn on down below? Do you see any lights lite down on the lower board?
-
Good luck
-
Still like a motor controller issue to me.
-
Its the console, just need complete model number to see what a console would cost.