KevinC
About
- Username
- KevinC
- Joined
- Visits
- 785
- Last Active
- Roles
- Member
Comments
-
can you get me the model number of the x5?
-
Great, if you need anything else just let us know.
-
Congratulations Erik!
-
Ok. just let me know if you have any other questions.
-
I would try that first. How old is the machine? It could be a friction issue between the belt and deck. The only other thing I can think of is a bad connection in the wiring somewhere. I don't think the controller is bad.
-
Have you lubricated the walking belt?
-
Is it in a program or manual? Is she using it right after you're done using it?
-
can you get me the specific model number of the 5000?
-
you'll need to replace the whole console on this. the individual parts like the actual board is no longer available from the manufacturer
-
can you describe the symptoms? I'm thinking this is a motor controller failure.
-
yes, you'll need access to the top and bottom sections and you'll need a multi-meter set to resistance/ohms. You're checking for shorts between the wires or between wires and ground.
-
what is the model number of your machine?
-
the controller has failed. can you get me the serial number?
-
Here is a code you can use on the checkout page for a discount (5offkevin)
-
check this out; https://www.treadmilldoctor.com/walking-deck-reinforcement-kit
-
When you press the start button that light on the motor controller should start to flash. Double check the wire harness for a damaged wire.
-
you would need to replace the whole assembly
-
how much time between the 2 pushes of the incline button
-
I would use it right away
-
That is from the speakers. The only way to make that go away is to disconnect the speakers. the original board, which is no longer available is a 12W board, the replacement board is an upgraded board and it is a 30W board.
-
I'll need the specific model number of the A2350
-
They use the same board.
-
This machine needs a new motor controller. you can call me with the model number or you can use this link; https://www.treadmilldoctor.com/NordicTrack-COMMERCIAL-1750-Treadmill-Motor-Control-Board-445754 and Here is a code you can use on the checko…
-
Congratulations Jason
-
the walking belt
-
yes
-
They won't work together. They speak different languages.
-
There needs to be a way to communicate to the lower board. Our Treadmill Rescue Kit will work here. https://www.treadmilldoctor.com/Treadmill-Doctor-Rescue-Kit Here is a code you can use on the checkout page for a 5% discount. (5offkevin)
-
If you're lubricating the drive belt, that is where your problem lies. the drive belt does not get lubrication.
-
They are most likely Torx bit fasteners. if not, they'll be Phillips head screws.