KevinC
About
- Username
- KevinC
- Joined
- Visits
- 785
- Last Active
- Roles
- Member
Comments
-
I would use it right away
-
That is from the speakers. The only way to make that go away is to disconnect the speakers. the original board, which is no longer available is a 12W board, the replacement board is an upgraded board and it is a 30W board.
-
I'll need the specific model number of the A2350
-
They use the same board.
-
This machine needs a new motor controller. you can call me with the model number or you can use this link; https://www.treadmilldoctor.com/NordicTrack-COMMERCIAL-1750-Treadmill-Motor-Control-Board-445754 and Here is a code you can use on the checko…
-
Congratulations Jason
-
the walking belt
-
yes
-
They won't work together. They speak different languages.
-
There needs to be a way to communicate to the lower board. Our Treadmill Rescue Kit will work here. https://www.treadmilldoctor.com/Treadmill-Doctor-Rescue-Kit Here is a code you can use on the checkout page for a 5% discount. (5offkevin)
-
If you're lubricating the drive belt, that is where your problem lies. the drive belt does not get lubrication.
-
They are most likely Torx bit fasteners. if not, they'll be Phillips head screws.
-
They are most likely Torx bit fasteners. if not, they'll be Phillips head screws.
-
you should be able to lift the belt between 2-3 inches along the edges half way between the front and rear roller. Here is a link for the drive belt; https://www.treadmilldoctor.com/Proform-CARBON-TL-Treadmill-Drive-Belt-399309 and here is a link…
-
do you have the model number of the a2350? This is a friction issue and the belts should be replaced.
-
Congratulations Michael
-
Congratulations Tom
-
try lubing the belt again. Use about an ounce of lube per application. if the issues persists, I would replace the belts.
-
I would lubricate the walking belt and then tighten the walking belt a little. The drive belt might need to be replaced too. do you have the specific model number?
-
pulse bar will lift away with the screen
-
There should be screws around the perimeter on the back side of the display/console.
-
send me a wider view picture and a picture of the console. kclay@treadmilldoctor.com
-
you would be bypassing the console signals and wiring the 120VAC motor directly to a switch. It's not an ideal way to do it but it will work.
-
The only way to bypass the incline buttons on this one is with a momentary double pole double throw switch. All the wiring in the console is low voltage and is sent as a signal to the lower board. In order to bypass the console you would need to con…
-
congratulations Dan.
-
incline it up partially and let me know if the noise goes away
-
you might try a place called fitnessgraveyard.com
-
Congratulations John
-
Sounds as if he controller is starting to fail.
-
This is usually a sign that the belt needs to be lubricated or replaced. Try doing an Amp Draw test on the belt. https://www.treadmilldoctor.com/dc-amp-draw