admin-it
About
- Username
- admin-it
- Joined
- Visits
- 3,293
- Last Active
- Roles
- Administrator
Comments
-
Try this. www.treadmilldoctor.com/mc70-surging-fix
-
What type of treadmill do you have, what is the model number of the treadmill,
-
Good luck with your new treadmill.
-
You can try this. ENTER ENGINEERING MENU NAVIGATE THROUGH MENU SELECT MODES EN90 EN91 EN92 EN93 EN94 Press and hold the Incline Up/Plus and Speed Down/Minus for 3-5 seconds. Incline Up/Plus Incline Down/Minus Speed Up/Plus Speed Down/Minu…
-
Michele, Sounds like it may be the lower board that could be the problem, the cost of that is $109.99 plus $6.99 shipping. You could also take apart console and check at the connections and she if that helps.
-
You will need to contact icon for this issue.
-
Sounds like it could be a drive motor or motor controller board.
-
The belt & deck builds up friction when you walk/run on it, without proper deck lube you can cause the motor controller to overheat and shut down. Walking Belt Lube Instructions World Famous Treadmill Lube This lube works on most manufacturer's …
-
Sounds like you have a motor controller issue, but also I would recommend to lube the Belt & deck and may have to replace the Mylar or the Running belt.
-
Yes , you can do the repair yourself.
-
You would have to take covers off and look inside as you are using it to see what is making the noise.
-
You will need to replace the motor controller
-
You will need a new running belt and this happen because a lack of belt lube on the underside.
-
I would cancel order and order from somewhere else.
-
only with special equipment.
-
Pedman. I would recommend that you replace the choke part# 185582 and also to lube the belt. https://www.treadmilldoctor.com/walking-belt-lube-instructions
-
Testing for Speed Problems 1. You may have a belt and deck problem. Test by the following procedure: a) without the power on stand on the walking belt b) push the belt in the direction it normally turns c) if the belt is very difficult to turn (on m…
-
Are you sure the unit is not in the metric mode?
-
Sounds like either a motor or motor controller, when was the last time you lube the walking belt & deck.
-
No you won't need the serial number since pacemaster is no longer around, we have mostly all the parts for that treadmill.
-
You would really need to contact life fitness direct on those error codes.
-
When you press the start button on console, does your time start to count up on the console? If not then its a console issue.
-
Sounds like the Motor Controller has gone bad.
-
So the speed on the console will increase but the motor speed will not, sounds like a lower motor controller.
-
Do you have the safety key install on console?
-
Sounds like you will need a new incline motor.
-
depending on what proform you purchase the mcb can be between $99.99 up to $199.99
-
You would need to contact manufacture for parts & service.
-
Sounds like the belt and deck needs to be lubricated.No waxing is required for the first year of use. After one year it is recommended to wax the deck once every 6 months. This will enhance the performance and life of the Treadmill. Weight can have …
-
You would need to contact johnson fitness at 608-839-1240 or email them at service@johnsonfit.com