admin-it
About
- Username
- admin-it
- Joined
- Visits
- 3,291
- Last Active
- Roles
- Administrator
Comments
-
The relay board is no longer available.
-
You should be able to lift edge of belt 2 to 3 " on each side, sound like belt was over tighten. You should lube deck every 6 months.
-
send me you email and I can send you the service manual for this unit.
-
I would take console apart unplug ribbon cable that goes from key pad to PCB and the clean the ends and then plug back in and see if it works.
-
I would take the hood cover and see if you can see where belt is hitting or rubbing, you can also take a picture of the belt and email it over to me at jvonwiegen@treadmilldoctor.com
-
You may want to see what chest strap the fuel unit suggest you use.
-
Sounds like maybe a motor controller issue
-
Please call us at 888 362 1105 ext 331 ask for jim
-
Send us a picture of the speed sensor and I will see if we have something like that.
-
who is the treadmill made by.
-
Sole fitness f63 or f80
-
Sounds like a upper console issue.
-
Good luck
-
Yes a wire harness runs down the right upright if you are standing on the unit from console down to the motor controller which is under the hood cover.
-
Yes it is.
-
May want to check for pinch wires in the main harness.
-
Err Code 01 through 18 - (Button Error) Indicates the keyboard membrane has a stuck key. Do not hold down any key for more than 5 seconds or this error will appear. 1. Insert the magnetic key back into the control panel and do not touch any keys, if…
-
Good luck
-
https://www.treadmilldoctor.com/treadmill-belt-bogs-down
-
Take console off and look at the back of PCB and you will see a button.
-
https://www.treadmilldoctor.com/treadmill-belt-bogs-down
-
I would test the amp draw https://www.treadmilldoctor.com/dc-amp-draw and maybe test motor after it shuts down on you https://www.treadmilldoctor.com/motor-testing
-
Try that and see how you make out.
-
Sometimes you can find them at a sears hardware store or try a electric motor shop the rebuilds electric motors
-
No it should be above the deck some so air can flow underneath.
-
No those parts are no longer available.
-
On some of the old controllers, the polarity between the red and black wires are reversed. If your incline motor runs backward (up is down and down is up) then you will need to follow the red and black wires from the harness to the terminals they p…
-
On some of the old controllers, the polarity between the red and black wires are reversed. If your incline motor runs backward (up is down and down is up) then you will need to follow the red and black wires from the harness to the terminals they p…
-
Sometimes the side rails are held down with two way tape.
-
Err Code 01 through 18 - (Button Error) Indicates the keyboard membrane has a stuck key. Do not hold down any key for more than 5 seconds or this error will appear. 1. Insert the magnetic key back into the control panel and do not touch any keys, if…