DTW1975
About
- Username
- DTW1975
- Joined
- Visits
- 0
- Last Active
- Roles
- Member
Comments
-
Ah, ok. I appreciate the help. I figured it was likely the board. Hmm...decisions.
-
This is right above bar code on bezel cover: 5638 1011 1105 1625
-
BE402256L00575 This is the number right beneath the barcode on the board
-
Ha! Damn, do you believe it is worth attempting to repair or just try and purchase one? I did check the transistors on the heat sink and they are reading within acceptable range. None are reading open. For all I know it could be a faulty resistor, I…
-
It did just that.
-
Just tried that, sensor reading 20 ohms. So continuity is now there.
-
Negative, I will try that.
-
Actually, I just did a continuity test and there was no continuity on the sensor
-
I was able to see the green led blinking as I hand spun the motor. The rate of the blinking would change with respect to the motor speed. I did not use a continuity test on the sensor though.