rajnp
About
- Username
- rajnp
- Joined
- Visits
- 12
- Last Active
- Roles
- Member
Comments
-
I ordered the motor from you and got it, but now problem is I can not put back the drive belt on pulley. I have not fully tighten the motor bolts yet but still can not put back belt on both pulley
-
I took out old motor from treadmill but I can not remove flywheel from it as it is very hard to remove.I will need this flywheel if I get motor from you. How to remove flywheel.. I have tried so much but no luck
-
ok thanks..Do you sell controller also.What will be controller for Proform 525CT PFTL49617.0 on your website. My current controller is MC1618DL ZC0547 REV A
-
Should I replace the motor or not at this point. or both motor and controller How much the DC voltage should be at A+ and A- on controller with motor connected and motor disconnected
-
I replaced the mosfet on controller also still same numbers
-
I tested with both motor connected and disconnected, both time it was same DC 167volt
-
no motor was disconnected
-
But what for 167v dc from controller to motor, this can damage the new motor also? or this high voltage at A+ and A- are normal
-
Resistance between + and - of motor is also infinite and its not 5 to 10 ohms
-
Was planning to order replacement motor but than thought if 167v DC can blew new motor also