captiancrash
About
- Username
- captiancrash
- Joined
- Visits
- 42
- Last Active
- Roles
- Member
Comments
-
So I replaced the controller. I went to calibrate the speed and so I entered the calibration menu 2, moved the speed up to 85. It immediately showed 8.2/12 (assuming that's slow as they recommend 11.7/12. After that it's showing 0.0. I went ba…
-
I'll start there. Thanks
-
Ok I ran the multimeter test. On 2.5mph and no load the meter showed consistently 2.2-2.7amps draw With a load, it drew about 7-9amps, with it spiking 10 only when I got on, or if it made an effort to step down hard. I then watched…
-
I didn't quite do an amp draw test as I'm waiting for a multimeter. But I do have a wattage meter that tests the draw from the electrical outlet. I set the treadmill to 3.0mph and the treadmill used about 75-80 watts (fluctuating). At times I …
-
I just ran the treadmill at 1mph and after about 20 seconds it just throttled down to almost a dead stop (without me on it). The only reason I question the belt is because we haven't used it enough over the years (in my opinion) it's been unused fo…
-
Are there any other tests I can perform to test the belt? Another symptom I've noticed is that it runs with a hissing noise, like the belt is completely sitting on the deck and its dragging.