teddy57
About
- Username
- teddy57
- Joined
- Visits
- 2
- Last Active
- Roles
- Member
Comments
-
Just bought a brand new Sole F63. thanks
-
Sounds like it may be in the Motor controller but issue may be caused by worn running belt and a lack of lube, you give it very a of use and if this is your first time lubing the deck it may be to late. Well it's funny you say that, because the d…
-
Any ideas admin?
-
Update: went home at lunch and checked the drive belt, it was a little off center on the deck end pulley, so I loosed the deck belt and adjusted the drive belt. Retighted the deck belt until slipping stopped, no tighter. The treadmill still sh…
-
drive belt too tight??
-
DC Amp Draw Measure on the hot DC lead (usually red) going from the controller to the drive motor. If you have a simple multi-meter with a DC amp test setting the best way to test is to put the meter inline on the red motor lead with alligator clips…
-
DC Amp Draw Measure on the hot DC lead (usually red) going from the controller to the drive motor. If you have a simple multi-meter with a DC amp test setting the best way to test is to put the meter inline on the red motor lead with alligator clips…
-
I would take a amp draw reading with load and with out, also i would lube the belt and deck if not done already. Belt/deck have been lubed liberally about 5 times since this all started. How would I take an AMP draw? Thanks
-
Morning update, treadmill is shutting off again before the 1 minute mark on 20 straight occasions. Checked all wiring, changed outlets, etc and it kept shutting off...
-
Update, is there anyone out there?! I read somewhere online that GFCI outlets and treadmills don't mix, so I plugged the treadmill into a standard outlet and tested the treadmill for 10 minutes, treadmill did not shut down. Motor has been…
-
Update, went down for my 30 minute after dinner walk, the treadmill now runs for between 30-55 seconds before shutting down, and going through the procedure in the video. The treadmill did this about 15 straight times. Very frustrated right now!! He…
-
Also forgot to add, the motor temp and smell seem to be better since lubrication, but I am still concerned that something more might be wrong? Thanks
-
I noticed on another thread that the motor heating up could be from the belt/deck not being lubricated (which I haven't done yet since I bought it). So I went home at lunch time and liberally lubricated the deck/rollers,etc twice and tested for 15 …