tporter2360
About
- Username
- tporter2360
- Joined
- Visits
- 16
- Last Active
- Roles
- Member
Comments
-
Used replacement board does precisely the same thing. That is with the motor/transmission removed so there is no torque overload involved. Incline sensor connected as appropriate. Control panel? If so, I guess that this unit will be a flat track…
-
Connected AC/common to leads of incline motor/transmission directly without going through Power Supply Board. Motor runs as expected, screw shaft turns as expected and reverses perfectly with power switch from red to black. Reconnected to board an…
-
Removed the incline motor/transmission. Between incline 1 and 10 the shaft only turns about 180 degrees. Obviously not right. Transmission problem or motor control?
-
After running the belt drive motor for a few minutes it seems to work OK . . . at the moment. This machine hasn't been used in at least 6 years. Maybe just the commuter/brushes just needed cleaning. The incline still goes 'click' but no movement.…