Nordic Track C2000 NTL1084

rchance34 · August 2022

I have a Nordic Track C2000 NTL1084. The console powers up OK but when we start the belt it starts fast for less than a second and stops. Then the console shuts down and restarts. I went to follow the troubleshooting instructions but they say to hold the stop and speed button then insert the key. Which key are they talking about ? I have 10 keys for the belt speed plus a + sign and a - sign.

KevinC · August 2022

This is a failed motor controller. Here is a link for the part; https://www.treadmilldoctor.com/nordictrack-c2000-treadmill-motor-control-board

KevinC · August 2022

Also, here is a discount code you can use on the checkout page. (5offkevin)

KevinC · August 2022

for the calibration, its the stop and + buttons to enter calibration.

rchance34 · September 2022

after installing the board I did the calibration procedure but could not set the speed lower than 11.3 and my highest is 10. does this cause any problems or is there something else I should do?

KevinC · September 2022

Typically, that would be ok. Try the machine and let me know if it works ok.

rchance34 · September 2022

after installing the new board

KevinC · September 2022

yes

rchance34 · September 2022

I tried the machine and it does seem to work OK except the speed appears to vary as I am walking on it. I started out on a slow speed #3 to test and it varied between 2.7 and 3.2.

KevinC · September 2022

Make sure the belt is well lubricated. dry spots can cause that.

Howdy, Stranger!

Categories

Nordic Track C2000 NTL1084

Comments

Howdy, Stranger!

Quick Links

Categories

Nordic Track C2000 NTL1084

Comments